Green Terminator will work on any green infestations without any heavy preparation or pre-treatment required. For the best results, we recommend you use a stiff brush to remove the top-layer of growth.
Mix Green Terminator Remover or Inhibitor with cold water with a dilution rate based on the level of infestation that you are treating. Apply on with with a standard gardening watering can, or a low pressure pump sprayer for the best results.
In most cases, results can be seen within 24-48 hours. This depends on the weather and ambient conditions in your area, so we suggest waiting up to 72 hours to see the full results.
Once effects are seen, you can get rid of the residue immediately by using a high pressure hose to wash down the surface. Alternatively, weather and general footfall will do that job for you over the proceeding days.
Decking Cleaner can be used by anyone and only requires a few basics. As a powder-cleaner, Decking Cleaner must be mixed with hot water and brushed on directly to your decking. You will need the following:
Mix a few scoops of Decking Cleaner with hot water until the powder has dissolved completely. This should only take a couple of minutes. Pour the solution on to your decking and scrub it on - particularly for heavily contaminated areas.
After scrubbing on, wait for around 3-5 minutes for the solution to work. Next, pressure wash or hose away the residue to make your wooden decking look as good as new! Store your extra Decking Cleaner for year-round use.
]]>A powerful solution for cleaning stubborn stains from render, concrete, paving, stone and roof tiles. Results can be seen within 10 minutes of use!
]]>Render Cleaner requires a low pressure pump sprayer for application. We have a selection of over-shoulder sprayers and knapsack sprayers available in a range of sizes - including 4 litre, 8 litre, 12 litre and 20 litre tank capacities.
Prior to application, hose down any surrounding surfaces (including plant beds, window frames, doors...) that you don’t want to treat with clean cold water. This will form a protective layer that will last while you use Render Cleaner.
Using your low pressure sprayer, apply a sample onto a small test area of the surface that you would like to treat and leave for 10 minutes. Wash off to see the difference Render Cleaner will make and proceed if you are happy.
Fill your low pressure sprayer with a sufficient amount of Render Cleaner (leaving space for air compression) and spread an even mist over your dry surface, applying generously to more stubborn stains. Wait for around 10-15 minutes.
Some residual stains may remain is heavily contaminated areas, but can be easily removed with a stiff brush. Finish by rinsing off the surface with clean water (ideally with a hose) and your surface will look as good as new!
]]>